Products

Contact

Address: No.166 Daoxiang Road, Shushan New Industrial Park, Hefei City
Tel: +86-551-62522587

       +86-551-62522588
Mr. Xia:  +86-13905606066
E-mail: ahjl2014@163.com

JL-5H-12 Batch Circulation Grain Dryer

Passed ISO9001 quality management system, environmental management system, occupational health and safety management system certification

Key words:5H Series Grain Dryer | 5L Series Hot Blast Stove

Product Description

JL-5H-12低温循环烘干机

 

JL-5H-12 low temperature circulation dryer main parameters table
JL-5H-12 Batch Circulation Grain Dryer JL-5H-12
Structure type Fixed
Machine quality 2365Kg
Overall dimensions (L × W × H) 3732×2716×9600 mm
heating method Simply heating
Processing method Batch cycle
Cycle batch volume (batch cycle) 12T
Hourly throughput paddy ≥700Kg/h
Total motor power 6.82Kw
Rated voltage / frequency Three-phase 220V/380V  50HZ/60Hz
Hot air temperature 45-125℃
The highest valley temperature 30-38℃
Cycle time About 60min
Machine performance Out of the valley time About 50min
Into the valley time About 55min
Drying rate The general temperature is about 0.85%
Burst rate ≤2.0%
Dry type Rice, corn, wheat, soybeans, sorghum, mung beans and various kinds of seeds
Safety devices Temperature control device, fault alarm device, wind pressure light, full grain alarm, control fuse, thermal relay;
Other devices Full grain switch, computer moisture detector, timer switch, abnormal overheating, remote control

 

The grain dryer is an assembly of a dryer. It is a general term for various equipment of grain drying machines. It can also be used as grain dryers, such as corn dryers, rice dryers, rice dryers, and wine residue dryers. The grain loading capacity should meet the requirements, and should not be too much or too little. Excessive loading can easily cause blockage; Too little loading not only reduces operational efficiency, but also affects drying quality. After the grain enters from the feed hopper, it is monitored by a moisture detector inside the elevator. If the moisture detector fails to meet the monitoring standards, it is then transported through the elevator to the upper auger, the conditioning bin, and the drying bin for drying. Then, it is transported through the grain discharge wheel and the lower auger to the elevator for further testing. If it does not meet the standards, it continues to circulate. Otherwise, it enters the grain discharge pipe and is packaged, ending the process.

Online Message